Metal Ribbon Cork Board Frame!

I constitute METAL Ribbon at Hobby Lobby!
It's cute in addition to fun...and it volition rust if y'all permit it.
I convey a bunch of ideas for it, but I started amongst a cork memo board!
I used an sometime forest frame.
It was perfect because it was apartment in addition to boring.

I painted on a few coats of teal!

Now fourth dimension for the metallic ribbon.
I merely wanted a strip of it all roughly the frame.
I initially sentiment I would tack them inwards house amongst thumbtacks...but that didn't work.
So I used my staple gun. Easy...and genuinely matches better!

I tacked it downwardly on 1 corner

Then used wire cutters to snip the other terminate where it lined up.

Then stapled it inwards house a few times.
The staples blend inwards in addition to thus good that they aren't noticeable.

I did overlapping corners similar this, rather than doing a 45* angle.

Easy in addition to symmetrical!

The frame would await darling merely similar that...or amongst a film in addition to drinking glass inside...
but I decided to role cork board...

Then spray glued in addition to wrapped amongst cute polka dot fabric!

Then sprayed the dorsum of the cork board in addition to stuck it

directly to a thick foursquare of cardboard.

Then insert correct into the frame.

Then I used my film frame tool and glazier points.
Not everyone is every bit fortunate every bit I to convey a film frame setting tool...
but glazier points are made to laid upward amongst merely a apartment caput screwdriver too!

The glazier signal is designed to pierce into the frame,
amongst ii pocket-size arms that concur it against the frame, in addition to concur the backing inwards place.

My tool adjusts to fit the frame in addition to out to the glazier point.
(If using a screwdriver, you'll force the signal into the frame, braced on those ii footling arms.)