Wire Wrapped Tree Of Life Pendant!

 Wire Wrapped Tree of Life Pendant!

 To start y'all volition withdraw wire.
I got this at Joann Fabric as well as Crafts store.
You'll withdraw 26 estimate as well as sixteen estimate wire of the same color.

 Star alongside the sixteen estimate wire as well as shape a circle that's nigh two inches.

 Loop it at the top...

 And twist a footling loop for hanging.  Then wind the wire approximately the loop as well as clip the end.

 Now cutting 12 pieces of 26 estimate wire, nigh x inches long.

 Fold them inwards one-half as well as loop them over the circle.

 Twist them approximately the big wire a few times as well as squelch them together tight.

 Repeat for all 12 strands.

 Now accept the strands past times 3's as well as braid them.

 A liberate braid, but nigh 3/4 an inch long.

 Repeat until all 12 strands get got been braided.

 Pull the braids upwards inwards the pump of the ring.

 Twist them all together to shape the trunk...only twist them nigh 1/4" and
as well as hence start splitting the wires to shape branches.

 Twist a footling as well as hence dissever again...over as well as over...

 Until you've branded out your tree!
(pardon the excessive shadows)
Twist the wires approximately the exterior ring.

 Now, y'all tin flame add together beads to the branches...but I did this i bare.
Clip the remaining wire nigh 1 inch.

 Then role some jewelry pliers to twist as well as coil the wires to shape footling puffs.

 Repeat on all the wires.

 Hang on a chain!
Add some beads, a charm, or a moon!
Create a footling bonsai tree!

This post published on starting fourth dimension

Share this post