Foam Cake Stand Upwards Diy!

This is a sponsored post past times Floracraft®. All opinions in addition to arts and crafts ideas are mine!

Foam Cake Stand DIY!
#MakeItFunCrafts

I was sent this fabulous box of FloraCraft® Make It: Fun® Foam Discs

Influenza A virus subtype H5N1 huge diversity of discs also equally a cutter in addition to smoothen finish!

I needed a cake represent my sons birthday political party in addition to knew I could operate it 1 time to a greater extent than for Halloween!

You volition need:
1: 11" FloraCraft® Make It: Fun® Foam Disc
1: 10" FloraCraft® Make It: Fun® Foam Disc
1: 8" FloraCraft® Make It: Fun® Foam Disc
12: 4" FloraCraft® Make It: Fun® Foam Discs

I used hot gum in addition to glued iv modest discs to the largest 1 for the base.

Then I stacked iv modest discs high inward the center.

Added the side past times side largest disc, iv modest in addition to thus a modest topper!

Then I used a butter knife to spread the smoothen goal over the large disc surfaces.

It's lightweight in addition to spreads on only similar icing!
It fills inward all the opened upwards cells in addition to gives it a smoothen finish--imagine that!
Let it dry out completely. Then yous tin sand the goal downwards to smoothen out whatever difficult lines.

Next I spray painted it outside.
And allow it dry out overnight.

Next I used a spool of satin ribbon...
Just a slice long plenty to wind only about the cellular foam edges of each tier.
Then I used a instantly pivot to concur the ribbon inward place.